Step 1：
ssh登陆OpenWrt，上传 update-amlogic-openwrt.sh 脚本文件（update-amlogic-openwrt.sh 点此下载）、下载完成的固件（.img/.img.gz格式均可）上传至 /mnt/mmcblk2p4 目录
Step 2：
回到ssh终端然后执行
cd /mnt/mmcblk2p4
chmod +x update-amlogic-openwrt.sh
./update-amlogic-openwrt.sh openwrt_s905d_n1_Rxx.x.x_kx.xx.xxx.img
然后按照提示操作即可
更新过程中如提示输入设备编号请输入N1对应的设备编号
其他选项不知道如何选择的选择默认选项即可
(注意：openwrt_s905d_n1_Rxx.x.x_kx.xx.xxximg 为解压之后的镜像文件名，请根据实际情况修改)
Comments | 12 条评论
Boot The partition does not exist, so the update cannot be continued! 这个是什么错
@lucifer 要刷入emmc之后才可以使用脚本更新，否则只能先备份，U盘刷新版本后还原了
@myan 挂U盘的只能备份，重新写镜像然后再还原吗？
@lucifer 建议1: 用 bash /usr/sbin/reset 命令还原 etc-000 或 etc-001 快照之后重启
建议2: cp /.snapshots/etc-000/config/fstab /etc/config/ # 然后重启
Dependent command: per1 does not exist, upgrade cannot be performed, only flash through U disk/TF card!
原系统是flippy-54+o , 为啥只能通过U盘升级呢
刷入后在进入后台点击接口进行设置的时候提示这个
/usr/lib/lua/luci/dispatcher.lua:474: Failed to execute arcombine dispatcher target for entry ‘/admin/network/network’.
The called action terminated with an exception:
/usr/lib/lua/luci/ccache.lua:70: error loading module ‘luci.cbi’ from file ‘/usr/lib/lua/luci/cbi.lua’:
cannot read /usr/lib/lua/luci/cbi.lua: I/O error
stack traceback:
[C]: in function ‘assert’
/usr/lib/lua/luci/dispatcher.lua:474: in function ‘dispatch’
/usr/lib/lua/luci/dispatcher.lua:126: in function </usr/lib/lua/luci/dispatcher.lua:125>
请问se和pro的包也通用吗
@lm3344 不，这个不是针对X86架构
can’t unmount /dev/loop0p1:Invalid argument retry…，一直循环。。
挂载 /dev/loop0p1 -> /mnt/mmcblk2p4/boot … mount: mounting /dev/loop0p1 on /mnt/mmcblk2p4/boot failed: No such file or directory
挂载失败!
查看了一下的确没有loop0p1这个文件，用的你的上一版固件
无法连接到docker守护进程（docker daemon），请检查!!
请问怎么办
Itís hard to come by educated people about this topic, however, you seem like you know what youíre talking about! Thanks